GMC Code C0161 04

When it comes to modern automotive systems, the GMC Code C0161 04 is an important diagnostic code to be aware of. It is an ABS brake switch circuit open circuit code, and it is used to alert the driver of an issue with the antilock braking system. This code is triggered when the brake pedal switch is sensed as unapplied while the pressure sensor and travel sensor indicate that the brake pedal is applied. To ensure a smooth and safe driving experience, it is essential to understand the causes and solutions of this code. Here is a table outlining the causes and solutions of this code.

Causes and Solutions of GMC Code C0161 04

Cause Solution
System Internal Failure Replace the control module with a new one.
Corroded wiring or connectors Clean the wiring and connectors and replace if necessary.
Defective brake pedal switch Replace the brake pedal switch.
Defective pressure sensor Replace the pressure sensor.

System Internal Failure

When it comes to GMC Code C0161 04, one of the most common causes of the code is a system internal failure. This could be due to a malfunctioning control module, or an issue with the wiring or connectors. In some cases, the control module may be damaged beyond repair and will need to be replaced with a new one.

Corroded Wiring or Connectors

Another common cause of GMC Code C0161 04 is a corroded wiring or connectors. The corrosion may be caused by exposure to moisture or other environmental factors, or it may be due to wear and tear. In this case, the best solution is to clean the wiring and connectors and replace them if necessary.

Defective Brake Pedal Switch

The brake pedal switch may also be to blame for triggering GMC Code C0161 04. The brake pedal switch is responsible for sending a signal to the control module when the brake pedal is applied. If the brake pedal switch is malfunctioning, it will not send the appropriate signal and the code will be triggered. To fix this, the brake pedal switch needs to be replaced.

Defective Pressure Sensor

Finally, a defective pressure sensor may also cause GMC Code C0161 04. The pressure sensor is responsible for detecting the pressure applied to the brake pedal. If the pressure sensor is not working properly, it will not send the correct signal to the control module and the code will be triggered. In this case, the pressure sensor needs to be replaced.

Conclusion

GMC Code C0161 04 is an important diagnostic code that is used to alert the driver of an issue with the antilock braking system. To ensure a safe and reliable driving experience, it is important to understand the causes and solutions of this code. The most common causes of GMC Code C0161 04 are system internal failure, corroded wiring or connectors, a defective brake pedal switch, and a defective pressure sensor. The solutions for these causes include replacing the control module, cleaning the wiring and connectors, replacing the brake pedal switch, and replacing the pressure sensor. It is important to address GMC Code C0161 04 as soon as possible to avoid any further damage and ensure a safe and reliable driving experience.

https://www.youtube.com/watch?v=CeugeirQ7sg

5/5 - (276 votes)
Categories GMC

Leave a Comment