RAM Code P0876

A RAM P0876 Error Code is an issue associated with the transmission system, where five pressure switches are used to monitor the fluid pressure in the L/R, 2C, 4C, UD, and OD clutch circuits. If any of these pressure switches fail, then the RAM P0876 Error Code will be indicated, and it is important to identify and rectify the cause of the issue. This article outlines the possible causes and solutions associated with a RAM P0876 Error Code.

Possible Causes and Solutions for RAM P0876 Error

Cause Solution
Related Relay DTCs Present Diagnose and repair the related relay DTCs
Low Fluid Level Top off fluid levels in transmission system
No. 2 Check Ball Cut or Damaged Replace the damaged check ball
Low Line Pressure Check the line pressure and adjust if needed

Related Relay DTCs Present

A Diagnostic Trouble Code (DTC) is a signal that is sent to the Powertrain Control Module (PCM) to indicate a failed component or system. If there are any other related relay DTCs present, they must be diagnosed and repaired before the RAM P0876 Error Code can be resolved.

Low Fluid Level

If the fluid level in the transmission system is low, it can cause a RAM P0876 Error Code to be indicated. The fluid level must be checked, and if needed, topped off with the proper fluid for the transmission system.

No. 2 Check Ball Cut or Damaged

The No. 2 check ball in the transmission system can cut or become damaged due to wear and tear. This can lead to the RAM P0876 Error Code being indicated, and the check ball must be replaced if this is the case.

Low Line Pressure

The line pressure in the transmission system must be checked and adjusted if needed. Low line pressure can cause a RAM P0876 Error Code to be indicated, and the line pressure must be increased if needed to resolve the issue.

Conclusion

A RAM P0876 Error Code is an issue associated with the transmission system, and can be caused by a number of different issues. This article outlines the possible causes and solutions associated with a RAM P0876 Error Code, including related relay DTCs, low fluid levels, a damaged or cut No. 2 check ball, and low line pressure. It is important to identify and rectify the cause of the issue in order to resolve the RAM P0876 Error Code.

https://www.youtube.com/watch?v=e0M5pRMTfBw

5/5 - (241 votes)
Categories RAM

Leave a Comment