Having a Dodge vehicle with an error code P0760 can be a real pain. The code indicates an OD Solenoid circuit issue, and can put the transmission in limp-in mode if the failure is detected above 35 km/h (22 mph). This can cause a lot of inconvenience and even worse, a costly repair. It is important to understand the causes and solutions of this error code in order to keep your Dodge running smoothly and efficiently.
Causes and Solutions of Dodge Code P0760
| Cause | Solution |
|---|---|
| Related TCM Power Input DTCs Present | Check the power input from the TCM and replace if necessary |
| OD Solenoid Control Circuit Open | Check the circuit wiring and repair any breaks or loose connections |
| OD Solenoid Control Circuit Shorted to Ground | Inspect the circuit wiring and repair or replace any damaged or corroded components |
| OD Solenoid Control Circuit Shorted to Voltage | Check the voltage in the circuit and remove any sources of excessive voltage |
| Transmission Solenoid/Pressure Switch Assembly | Replace the solenoid/pressure switch assembly if it is faulty |
| Powertrain Control Module (PCM) | Replace the PCM if it is faulty |
When Dodge code P0760 occurs, it is important to first check for any power input related diagnostic trouble codes (DTCs) from the transmission control module (TCM). These DTCs indicate that the TCM is not receiving the correct amount of voltage and should be addressed prior to attempting to diagnose the P0760 code. If the power input is found to be faulty, it should be replaced or repaired as necessary.
OD Solenoid Control Circuit Open
A common cause of Dodge code P0760 is an open OD solenoid control circuit. This means that the circuit is not making an electrical connection between the TCM and the solenoid, resulting in the code being set. To remedy this, it is important to check the circuit wiring and repair any breaks or loose connections.
OD Solenoid Control Circuit Shorted to Ground
If the OD solenoid control circuit is shorted to ground, this can also cause Dodge code P0760. In this case, it is important to inspect the circuit wiring and repair or replace any damaged or corroded components.
OD Solenoid Control Circuit Shorted to Voltage
The OD solenoid control circuit can also be shorted to voltage, which will also result in Dodge code P0760. To resolve this, it is important to check the voltage in the circuit and remove any sources of excessive voltage.
Transmission Solenoid/Pressure Switch Assembly
The transmission solenoid/pressure switch assembly can also be the culprit behind Dodge code P0760. If this component is found to be faulty, it should be replaced to resolve the issue.
Powertrain Control Module (PCM)
In some cases, the powertrain control module (PCM) can be the cause of Dodge code P0760. If this is found to be the case, the PCM should be replaced.
Conclusion: Resolving Dodge Code P0760
Dodge code P0760 indicates the presence of an issue in the OD solenoid control circuit. This code can be caused by several different issues, such as related TCM power input DTCs, an open circuit, a shorted circuit, a faulty transmission solenoid/pressure switch assembly, or a faulty powertrain control module (PCM). In order to resolve this issue, it is important to identify the cause and take the appropriate corrective action. By understanding the causes and solutions of Dodge code P0760, owners can ensure that their Dodge vehicles remain running smoothly and efficiently. With the right diagnosis and repair, Dodge owners can get their vehicles back on the road quickly, avoiding costly repairs and the inconvenience of limp-in mode.