The Honda Code P1165 is an issue that can cause a wide range of problems in Honda vehicles. This code is a type of diagnostic trouble code (DTC) and is triggered when the Powertrain Control Module (PCM) detects the Lean A/F-11 (Bank 1 Sensor 1) Range/Performance. This code is triggered when the vehicle is driven at an engine speed of 1500-2500 rpm at 45-60 mph for 2-3 minutes and then decelerated back to idle speed with the throttle closed. The PCM detects if the Lean A/F-11 Sensor signal is too high or too low during the Heated Oxygen Sensor (HO2S) test. To diagnose and repair this code, it is essential to understand the potential causes and possible solutions.
🚀Recommended article: Honda Code P0507
Causes and Solutions for Honda Code P1165
| Causes | Solutions |
|---|---|
| LAF signal circuit is open or grounded (intermittent fault) | Check for any breaks or corrosion in the LAF signal circuit |
| The LAF signal circuit is shorted to heater power (intermittent) | Inspect the wiring and connectors for any short circuits |
| LAF may be contaminated or may have failed | Replace the LAF sensor if necessary |
| PCM has failed | Replace the PCM if necessary |
Intermittent Faults
Intermittent faults, such as a broken or corroded LAF signal circuit or a short circuit in the heater power circuit can cause the Honda Code P1165. If these types of faults are present, the PCM will detect the fault and set the code. The technician should inspect the wiring and connectors for breaks or corrosion to remedy these issues. If any of these issues are found, they should be repaired or replaced as needed.
Failed LAF Sensor
The LAF sensor can become contaminated or fail, resulting in a Honda Code P1165. The technician should inspect the LAF sensor for any signs of contamination or damage. If any of these issues are found, the sensor should be replaced.
Failed PCM
If the PCM has failed, it can cause a Honda Code P1165. The technician should inspect the PCM for any signs of failure. If any issues are found, the PCM should be replaced.
Conclusion
The Honda Code P1165 is an issue that can cause a wide range of problems in Honda vehicles. To diagnose and repair this code, it is essential to understand the potential causes and possible solutions. Some of the possible causes include intermittent faults, a failed LAF sensor, and a failed PCM. To remedy these issues, the technician should inspect the wiring and connectors, replace the LAF sensor if necessary, and replace the PCM if necessary. Proper diagnosis and repair of the Honda Code P1165 is essential for the proper operation of the vehicle.
https://www.youtube.com/watch?v=n6DzCQMde_E