Jeep Code P0426 is an error code that occurs when the Powertrain Control Module (PCM) is unable to detect the Catalyst Temperature Sensor Circuit Performance. This code is associated with four Exhaust Gas Temperature Sensors (#1, #2, Catalyst, and #3) that are used to monitor engine exhaust temperatures in the after-treatment system. The Catalyst Exhaust Gas Temperature Sensor is located between the Diesel Oxidation Catalyst (DOC) and the Diesel Particulate Filter (DPF). It sends a signal to the PCM indicating the temperature of the exhaust gases exiting the DOC and entering the DPF. This code can result in the malfunction indicator light being illuminated and active regeneration mode being disabled. In order to identify the cause of this code, it is essential to consider the various possible causes and solutions.
🎯Suggested article: Jeep Code P0670
Causes and Solutions for Jeep Code P0426
| Cause | Solution |
|---|---|
| Faulty Exhaust Gas Temperature Sensor | Replace the sensor |
| Damaged wiring or connectors | Check and repair any damaged wiring or connectors |
| Faulty PCM | Replace the PCM |
| Incorrect sensor output | Check if the sensor output is correct |
Faulty Exhaust Gas Temperature Sensor
The most common cause of Jeep Code P0426 is a faulty Exhaust Gas Temperature Sensor. This sensor is responsible for sending a signal to the PCM indicating the temperature of the exhaust gases exiting the DOC and entering the DPF. If this sensor fails, it will cause the PCM to be unable to detect the Catalyst Temperature Sensor Circuit Performance, resulting in the code being stored. In order to fix this issue, the faulty sensor needs to be replaced.
👀Look at this: Jeep Code P0105
Damaged Wiring or Connectors
Another possible cause of Jeep Code P0426 is damaged wiring or connectors. If the wiring or connectors become damaged, the signal from the Exhaust Gas Temperature Sensor may not be able to be detected by the PCM. In order to identify this issue, it is important to inspect the wiring and connectors for any damage visually. If any damage is found, it must be repaired before the code can be fixed.
👀Look at this: Jeep Code P0298
Faulty PCM
A faulty Powertrain Control Module (PCM) can also cause Jeep Code P0426 to be stored. If the PCM is faulty, it can prevent the Exhaust Gas Temperature Sensor signal from being detected. In order to fix this issue, the faulty PCM needs to be replaced with a new one.
Incorrect Sensor Output
The final possible cause of Jeep Code P0426 is incorrect sensor output. The Exhaust Gas Temperature Sensor must be sending a signal within the specified range for the PCM to detect it. The code can be stored if the sensor output is too high or too low. In order to identify this issue, it is essential to check if the sensor output is correct. If it is not, the sensor must be replaced.
⚡️Other article: Jeep Code P0934
Conclusion
Jeep Code P0426 is an error code that a variety of issues, such as a faulty Exhaust Gas Temperature Sensor, damaged wiring or connectors, a faulty PCM, or faulty sensor output, can cause. In order to identify the cause of the code, it is essential to consider the various possible causes and solutions. The most common cause is a faulty Exhaust Gas Temperature Sensor, but it is also essential to check for damaged wiring or connectors, a faulty PCM, and incorrect sensor output. If you are having trouble diagnosing Jeep Code P0426, it is best to seek professional help from a certified mechanic.