Jeep Code P0610 is the diagnostic trouble code (DTC) associated with the ECU Vehicle Options Mismatch. When this code is triggered, it indicates that the Powertrain Control Module (PCM) and the Body Control Module (BCM) have different readings of the module build configuration on the Controlled Area Network (CAN) Bus. This code can be caused by a variety of issues including a PROXI/CONFIGURATION MISMATCH, a USED CONTROLLER installed with the wrong configuration, a BCM not properly programmed, a module added or subtracted without changing the sales code, or a faulty Powertrain Control Module. Below is a table outlining the causes and solutions of Jeep Code P0610.
Causes and Solutions of Jeep Code P0610
| Cause | Solution |
| PROXI/CONFIGURATION MISMATCH | Check the PCM configuration and compare it to the BCM configuration. |
| USED CONTROLLER installed with the wrong configuration | Ensure the used controller is properly configured. |
| BCM not properly programmed or was replaced and not programmed | Reprogram the BCM. |
| Module was added or subtracted without changing the sales code | Change the sales code in the PCM. |
| POWERTRAIN CONTROL MODULE | Replace the PCM. |
When Jeep Code P0610 is triggered, it is indicative of an issue with the module build configuration of the PCM and BCM. This can be caused by a variety of things, including a PROXI/CONFIGURATION MISMATCH, a USED CONTROLLER installed with the wrong configuration, a BCM not properly programmed, a module added or subtracted without changing the sales code, or a faulty Powertrain Control Module. The solutions to each of these causes are outlined in the table above, which provides a comprehensive examination of the causes and solutions of Jeep Code P0610.
Fixing a PROXI/CONFIGURATION MISMATCH
If the cause of Jeep Code P0610 is a PROXI/CONFIGURATION MISMATCH, the solution is to check the PCM configuration and compare it to the BCM configuration. If the PCM and BCM configurations do not match, the issue must be resolved before the code can be cleared.
Replacing a USED CONTROLLER
If the cause of Jeep Code P0610 is a USED CONTROLLER installed with the wrong configuration, the solution is to ensure the used controller is properly configured. It is important to thoroughly inspect the used controller for any signs of damage and to ensure it is properly programmed before it is installed.
Reprogramming the BCM
If the cause of Jeep Code P0610 is a BCM not properly programmed or was replaced and not programmed, the solution is to reprogram the BCM. It is important to use a trusted and reliable programmer to ensure the BCM is properly programmed.
Changing the Sales Code
If the cause of Jeep Code P0610 is a module was added or subtracted without changing the sales code, the solution is to change the sales code in the PCM. This can be done using a professional-grade scan tool and should be done with care to ensure the code is changed correctly.
Replacing the PCM
If the cause of Jeep Code P0610 is a faulty Powertrain Control Module, the solution is to replace the PCM. It is important to use a reliable and high-quality replacement unit to ensure proper functioning of the PCM.
Conclusion
Jeep Code P0610 is the diagnostic trouble code associated with the ECU Vehicle Options Mismatch. This code can be caused by a variety of issues, including a PROXI/CONFIGURATION MISMATCH, a USED CONTROLLER installed with the wrong configuration, a BCM not properly programmed, a module added or subtracted without changing the sales code, or a faulty Powertrain Control Module. The solutions to each of these causes of the Jeep Code P0610 are outlined in the table above, providing a comprehensive examination of the causes and solutions of this code.
https://www.youtube.com/watch?v=oHn6JOYNH2o