When your Jeep’s check engine light turns on, you may be seeing the code P1694. This code indicates that there is an issue with the PCM Bus Messages, which means that the powertrain control module is not receiving any messages on the data bus for 10 seconds. If you’re seeing this code, it means that there is an issue with the data bus circuit that is either damaged, open, or shorted, or there is an intermittent wiring or connector problem. The PCM may also be unable to communicate with the body control module, or it has failed. In any case, it is important to diagnose and repair this issue in order to ensure the proper functioning of your Jeep.
Causes and Solutions for Jeep Code P1694
| Cause | Solution |
|---|---|
| Data Bus circuit connector is damaged, open or it is shorted | Check for any visible signs of damage and replace the connector as needed |
| Data Bus circuit to the PCM is damaged or it is open | Inspect the circuit for any signs of damage and repair or replace as needed |
| PCM unable to communicate with the body control module | Examine the wiring between the two modules and repair or replace any damaged wires |
| Intermittent wiring or connector problems exist | Check for any loose connections and replace the connector as needed |
| PCM has failed | Replace the PCM with a compatible unit |
Damaged or Open Data Bus Circuit
One of the most common causes of the Jeep Code P1694 is a damaged or open data bus circuit to the powertrain control module (PCM). This can be caused by a faulty connection or wire, or it can be caused by a short circuit in the wiring harness. To diagnose and repair this issue, you should inspect the wiring for any signs of damage and replace the connector as needed.
Intermittent Wiring or Connector Problems
Another cause of the Jeep Code P1694 is an intermittent wiring or connector problem. This can occur when the wiring or connector becomes loose or corroded. To diagnose and repair this issue, you should check for any loose connections and replace the connector as needed.
PCM Unable to Communicate with the Body Control Module
In some cases, the Jeep Code P1694 may be caused by the powertrain control module (PCM) not being able to communicate with the body control module. This can be caused by a faulty wiring or connection between the two modules. To diagnose and repair this issue, you should examine the wiring between the two modules and repair or replace any damaged wires.
PCM has Failed
The last possible cause of the Jeep Code P1694 is a failed powertrain control module (PCM). If the PCM has failed, it will need to be replaced with a compatible unit.
Conclusion: Diagnosing and Repairing Jeep Code P1694
It is important to diagnose and repair Jeep Code P1694 as soon as possible in order to ensure the proper functioning of your Jeep. This code can be caused by a damaged or open data bus circuit, intermittent wiring or connector problems, or a failed powertrain control module. By diagnosing and repairing the issue, you can get your Jeep back on the road in no time. If you’re experiencing Jeep Code P1694, it is important to diagnose and repair the issue as soon as possible to avoid further damage to your vehicle.
https://www.youtube.com/watch?v=Qhasa7xPEG0